Washington health officials prepare for more flu

  • The Associated Press
  • Thursday, July 9, 2009 10:39pm
  • News

The Associated Press

SEATTLE — This spring’s swine flu outbreak hasn’t gone away in Washington state despite the summer weather, but health officials have a new challenge to focus on: preparing for next fall’s flu season, Washington Health Secretary Mary Selecky said Thursday.

People are still sick and recovering in Washington hospitals, with new cases reported each week. Since mid-April, 98 people have been hospitalized with the H1N1 virus in Washington and four people have died.

Selecky was in Bethesda, Md., Thursday, with representatives from emergency mamanagement and the state education department, for a national briefing on swine flu preparation for the fall. She said the takeaway message was make sure you’re ready for a very busy fall flu season.

“We already are very engaged with our local and tribal health partners for the work that needs to be done to get ready for what could be mass vaccination campaigns,” Selecky said in a phone interview with The Associated Press.

She was pleased with the high level of attention swine flu continues to get in the nation’s capitol despite the country’s pressing economic problems. Cabinet members briefed health directors from around the country and President Barack Obama called in from the G-8 summit in Italy.

A swine flu vaccine is still being tested, so health officials do not know yet if the H1N1 vaccine will require one or two doses. People should be ready to get either two or three flu shots this fall, Selecky said.

Who gets a shot will depend on availability of the vaccines and who federal health officials believe are the prime candidates for a severe case of swine flu.

Selecky encourages everyone to get a seasonal flu shot as soon as it becomes available in late summer or early fall — because the regular winter flu kills 36,000 Americans a year — and then wait to hear who will be getting the first swine flu shots when they start arriving in October.

The first doses of the H1N1 vaccine will go to health workers, school employees, young children and people with underlying health problems like asthma.

“There won’t be enough for everybody,” she said.

More in News

Fred Lundahl, a pilot from Whidbey Island, prepares to fuel up his 1968 Cessna Aerobat, named Scarlett, at the Jefferson County International Airport in Port Townsend. Lundahl was picking up his plane Wednesday from Tailspin Tommy’s Aircraft Repair facility located at the airport. (Steve Mullensky/for Peninsula Daily News)
Fueling up

Fred Lundahl, a pilot from Whidbey Island, prepares to fuel up his… Continue reading

After hours pet clinic set for Peninsula

Opening June 6 at Sequim location

Five to be honored with community service awards

Ceremony set Thursday at Port Angeles Senior Community Center

PASD planning for expanding needs

Special education, homelessness, new facilities under discussion

Clallam County Sheriff’s Office Animal Control Deputy Ed Bauck
Clallam Sheriff appoints animal control deputy

Position was vacant since end of 2024

Highway 104 road work to start week

Maintenance crews will repair road surfaces on state Highway… Continue reading

Supreme Court says no to recall reconsider

Sequim man found liable for legal fees

Chimacum Ridge seeks board members

Members to write policy, balance values, chair says

Fire destroys shop east of Port Angeles

A fire on Hickory Street east of Port Angeles… Continue reading

Jefferson Transit Authority to expand Kingston Express route

Jefferson Transit Authority has announced expanded service on its… Continue reading

From left to right, Northwest School of Wooden Boatbuilding students Krystol Pasecznyk and Scott McNair sand a Prothero Sloop with Sean Koomen, the school’s boat building program director. Koomen said the sanding would take one person a few days. He said the plan is to have 12 people sand it together, which will take a few hours. (Elijah Sussman/Peninsula Daily News)
Wooden boatbuilding school building ‘Twin Boats’

Students using traditional and cold-moulding construction techniques